Quantum Metagloves | Hand Straps
Note: This article applies to both Prime 3 Haptic XR Gloves and Prime 3 Mocap Gloves
Note: This article applies to both Quantum Mocap Metagloves and Quantum XR Metagloves.
Introduction
The Metagloves Textile Pack and the Metagloves Accessory Pack both include a set of Metagloves Hand Straps. Check out our webshop for further details.
Preparation
- Identify the left and right hand strap.
![](https://cdn.prod.website-files.com/61f1346be9b2882b854a2ece/65cdd562c3f70e145550e27a_straps-left-right.png)
- Remove the electronics module from the Metaglove textile.
![](https://cdn.prod.website-files.com/61f1346be9b2882b854a2ece/65cdd58c80554dc7bf53f080_strap-electronics.png)
Assembly
For this tutorial we will focus on the Left strap only.
- Attach the left hand strap to the left electronics module.
- Make sure the hand strap Velcro side goes through the hand strap loop and the electronics module cut out. (shown below)
- Make sure the hooks [1][2] of the hand strap are aligned with the two plastic cut outs and rotate the bottom hook [2] to lock in the electronics module to the hand strap
Wearing
- Next, insert your hand through the loop as shown below.
- Loop the Velcro strap below the thumb to the front and attach the Velcro strap to the Velcro adhesive. Tighten to fully secure the Electronics module.
- Loop the remaining Velcro strap to the palm side of the hand and tuck in any abundant Velcro strap, indicated by [3].
![](https://cdn.prod.website-files.com/61f1346be9b2882b854a2ece/65cddd3275164c8e94d30517_image8a.jpg)
- Lastly, connect the finger sensors to the finger tip clips.