MANUS Core 2.1 | Users Tab
Note: This article applies to both Prime 3 Haptic XR Gloves and Prime 3 Mocap Gloves
Note: This article applies to both Quantum Mocap Metagloves and Quantum XR Metagloves.
Here you will have an overview of all created User Profiles and its gloves.
Depending on your pipeline this will also include trackers used for hand positional tracking or full body capture.
This is the name you have set when setting up a new profile or have walked through the first time setup. The user name can be changed from the profile settings.
Starts the calibration process for the user
Will open the Profile Settings side panel where you can adjust and assign gloves and trackers to the user as well as change the user's profile name.
This dropdown allows you to see the gloves connected to this profile. It also lets you see the battery and signal status when hovering over their respective icons.
This dropdown allows you to see the trackers connected to this profile.
Opens a popup to create and setup a new user profile.
The order of user profiles can be changed by dragging and dropping profiles. This is useful for plugins that use the user's index to determine what data to stream to what model.
Name: Here you can see and change the users profile name
Remove Profile: This allows you to delete the current profile.
Calibrate: This will trigger the calibration process for the gloves only.
Dongle: This shows the dongle linked to the user profile for wireless glove use. If more than one dongle is connected, you can select them from the drop-down menu.
Left and Right Gloves: This shows the gloves assigned to the user profile. This can be manually changed using the dropdown.
Calibrate: This will trigger the calibration process.
Here you can tweak the users' specific body measurements to better match their physical proportions.
Make sure the viewport is set to Scene View to see the adjustments take effect.
APPLY & CLOSE
Applies any changes made and closes the profile settings.