Using wired gloves in MVN
Note: This article applies to both Prime 3 Haptic XR Gloves and Prime 3 Mocap Gloves
Note: This article applies to both Quantum Mocap Metagloves and Quantum XR Metagloves.
Introduction
The purpose of this article is to explain how to configure MANUS Core to use wired gloves in Xsens MVN.
Setting it up
Open the MANUS Core Dashboard.
Connect two gloves through USB to the computer or Bodypack and turn them on:
Configure the gloves either using the popup:
Or manually assign both gloves to a user:
Go to Settings and in the Hardware section enable Xsens wired glove workaround:
In the Devices tab now note the Dongle - Virtual with a left and right glove.
Expand the Dongle section and take note of the Dongle ID, this is the ID that will be used in MVN to
configure the hands.
Now open MVN and navigate to the Fingers tab in the Motion Capture Configuration
Select the Virtual dongle ID from earlier and select it from the dropdown.
When using a MANUS Quantum Bodypack please refer to the Networked Devices article for specific setup instructions.
You can now use wired gloves in MVN.
